This little snowman is made of papier mâché. For this, small balloons are glued with paper and paste and then designed. During this adventure, several children can also create a snowman together. Have fun!
First put out the craft pad and blow up two balloons. Then you put the paste, a brush and the white paper.
Then you tear the white paper in snippets first.
Then you pin a piece of the balloon into it with paste. On it you stick the snippets.
Paints the snippets again and again with paste and glues the whole balloon. So glues the balloon with several layers of paper snippets.
In the end, only the knots of the balloons look out.
Put the balloons on a glass and set them to dry.
You need to dry for several hours.
If the snippets are dried, check if you can still find open places.
These are places where the balloon shines through.
Once again, she glues them with snippets and pastes.
Then put the balloons back to dry.
When the balloons are dried, you cut the knot with a pair of scissors.
It can take a few minutes to get out of the air, and then you can pull out the balloon.
Tip: If you don't get the balloon out, just push it inside.
Now you put the two balls on top of each other, making sure the holes are on top of each other. You can push the balls a little bit, so that they stand well on top of each other.
Then you stick them together with hot glue.
Attention when handling the hot glue - burn risk!
Now you cut out circles from the black clay paper for the buttons, from the orange foam rubber a nose in the form of a carrot and with the punch you punch out stars for the mouth. The individual parts stick afterwards with the glue stick on the snowman.
Then you make the hat, you need the can and a circle of clay paper.
Tip: Use a small plate or bowl for the circle and round it. Then you can cut out the pre-drawn circle.
Then you punch out stars around the circle.
The stars stick to the can with the glue stick.
Now you stick the can on the clay paper circle. For this you use the hot glue. Drive around the can. Let the hat dry briefly.
In the meantime, you can make another scarf.
For this you cut off a strip of foam rubber and cut several times to the right and left about 1cm deep with the scissors.
Now you stick the hat with hot glue on the head of the snowman.
You also attach the scarf to it with some hot glue points.
Then you can decorate it, for example on a cardboard plate with cotton wool.
Have fun doing crafts!
Children 1
